hi !
Im playing around with the actual beta (in 4 days its official)
i have 2 ethernet devices, i setup one which is working which also includes default gateway. Now i want to add a 2nd segment and i made setup in netplan regarding Docu.
netplann generate neither netplan apply croaks in debug mode for any failue but the 2nd ip address does not appear on the interface.
the netplan config
Code:
network:
ethernets:
enp1s0:
addresses:
- 192.168.1.2/24
enp2s0:
addresses:
- 192.168.63.251/24
nameservers:
search: [domain.tld]
addresses: [192.168.63.1, 192.168.63.254]
routes:
- to: default
via: 192.168.63.254
version: 2
but ip address for enp1s0 is not set
Code:
enp1s0: flags=4099<UP,BROADCAST,MULTICAST> mtu 1500
ether 00:d0:b4:02:40:24 txqueuelen 1000 (Ethernet)
RX packets 0 bytes 0 (0.0 B)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 0 bytes 0 (0.0 B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
device memory 0x80e00000-80efffff
enp2s0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
inet 192.168.63.251 netmask 255.255.255.0 broadcast 192.168.63.255
inet6 fe80::2d0:b4ff:fe02:4025 prefixlen 64 scopeid 0x20<link>
ether 00:d0:b4:02:40:25 txqueuelen 1000 (Ethernet)
RX packets 1888295 bytes 1372768091 (1.3 GB)
RX errors 0 dropped 224009 overruns 0 frame 0
TX packets 498157 bytes 136051635 (136.0 MB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
device memory 0x80b00000-80bfffff
Did i missed an entry ?
Ciaso Gerd
Bookmarks